UPC 600740441196

• 32-bit MCU, high-precision 6-axis MEMS sensor, improved hardware platform and new firmware solution provide more reliable performance.
• 6 flight modes, including Gyro-Off mode, Normal mode, Trainer mode, Atti-Lock mode, Auto-Level mode and Auto-Hover mode.
• Compatible with most standard receivers, standard PPM single-line receivers and Futaba's S.Bus and S.Bus 2 receivers.
• External LED module, integrated with data interface, flat or upright various mounting orientations supported.
• Customizable hardware and software low pass filters for gyroscope and accelerometer, enable you to optimize the performance of the gyro as you wish.

Specifications Main Controller: 32-bit MCU Sensor: High-precision 3-axis gyroscope and 3-axis accelerometer Gyroscope Scale Range: ±2000 dps Accelerometer Scale Range: ±4g PWM Output: 920uS ~ 2120uS with 1520uS center length / 50 ~ 333Hz Input Voltage: 4.8V ~ 8.4V Operating Temperature: -10 ℃ ~ 50 ℃ Size: 43×27×14mm Weight: 10g (excluding wires) External LED Module An external LED module is added to make the gyro even easier and more convenient to install and use. Trainer Mode Trainer Mode is added. When flying in this mode, you can only tilt the plane to a certain angle by giving aileron or elevator stick input. Roll and loop are not allowed in this mode, the plane will be stabilized all the time. This prevents the plane from being tilted into a larger angle that may cause a danger. This mode can be used as emergency rescue, or in other applications, e.g. to have a training for new beginners or to use for FPV 6-position Mode Switching This new feature allows you to switch the flight mode among all modes supported during flight, by using a mixing of a 2-position and 3-position toggle switch on your transmitter Programming Examples for 6-position Switch Mixing Pass-through Channels Pass-through function is available for [A2] and [E2] channels. When the second aileron or elevator channel is unused, the input signal applied to [A2] or [E2] will directly be passed to the output [OUT4] or [OUT5]. With this feature, the [A2] and [E2] can be used as any other purpose as you need, e.g. throttle, gear or flap, etc