UPC 611138350570

This is a round ice cube tray maker made of BPA free black flexible unbreakable silicone that is food and drink safe. This mold makes 4 individual 1 1/2" diameter ice balls for your drinks. Slow to melt cubes keep your drinks colder for longer. Unique round shape adds fun to your party drinks! INSTRUCTIONS : Before using your new tray, be sure to wash to wash thoroughly with soap and water. Fill the bottom tray nearly full of water; leaving about 1 cm unfilled. Then set the bottom tray on an even surface in your sink and press the lid tray down into the bottom tray until it is sealed. (Note: The excess water will escape through the 4 vent holes at the top of each ball.) When full, gently press down on the top of each mold to force out enough water to give a slight air gap at the top of each ball for expansion. This step is important so your ice balls will form properly without cracking to leave room for expansion. (You are actually filling the mold up 80% with water or your preferred beverage.) Do not worry about excess water in tray you can let it freeze with the mold. Lay flat in freezer for 5+ hours. After freezing please follow these steps: Before removing mold lid, break all ice around balls using a twisting motion...with lid still on. If you do not, there will be Saturn-like rings around each ball. ( If you do get these, you can remove them by tapping them with a spoon and they fall off.) You do not have to be gentle with the silicone because it will not break. After using this step to break ice, remove the top lid and release the ice spheres from the bottom tray. Note: There may be some broken ice, but the balls should be fine. Ice balls are now ready for removal! Just use the ice balls you need and store the rest in a plastic zip-lock bag in your freezer.