UPC 759981187056

• Displacement: 3.45cc, Bore: 16.26mm, Stroke: 16.80mm, Practical RPM: 5000 - 41000 , Power Output: 2.65hp / 38,000rpm, Weight: 455g (1.0lb)
• It is engineered for superior torque and durability allowing you to unleash the full potential of your 1/8 Competition nitro Off Road Buggy and Truck.
• Long stroke engine provides more torque
• More powerful, more reliable, and easier to use
• Starting from: use the starter box

Note: To avoid the carburetor neck parts damaged and ovalized,also caused to not set well: Please fix the Carburetor Unit in The "CLOCKWISE DIRECTION" but not too closely.Engine Specs:Suit for: 1/8 scale Off Road Buggy Truggy nitro powered RC CarDisplacement: 3.45ccCarburetor: 7.5mm / 0.3inPiston diameter/Bore: 16.26mmPiston stroke: 16.80mmR.P.M: 38000rpmPractical Range: 5500/41000rpmPower: 2.65hpPorts: 5+2+2Exhaust Type: RearGlow Plug Type: TurboWeight: 353g / 12.45ozDimensions: 10.5 x 5.6 x 10.7cm / 4.16 x 2.2 x 4.2inPackage Information:1 x PR Racing D6-PRO 3.45cc Nitro Engine3 x Clutch Shoe3 x Clutch Springs1 x Sticker1 x Instructions Operation InstructionRunning-InFix the engine on the model and run it at low rpm for at least 30 minutes.Start Put the model on the starting box connect the glow plug to the specific device connected with a battery of 1.2-2.0 volt.Blow OutStop the engine by closing the needle valve through the remote radio control or use a rag to cover the exhaust tip. Be carefully The exhaust is extremely hot. So you must use a thicker rag.FuelUsing a good quality fuel to avoid rust and oxidation occurred in engine.Good fuel is composed of alcohol without water,good nitro and ungummed oil.Air FilterYou should carefully maintain the air filter to avoid dust and sand go into engine.Wisely ControlAccelerating the engine, let the pipe noise as quiet as possible to avoid skidding to the model.Sharp acceleration causes the balls of bearing skidding against their sliding guide and consequent wear